This file is ftp://ftp.livingston.com/pub/livingston/RELEASE_3.1.4


Here are the release notes for ComOS 3.1.4, available from
ftp://ftp.livingston.com/pub/livingston/upgrades/pm2_3.1.4
ftp://ftp.livingston.com/pub/livingston/upgrades/pm25_3.1.4


To upgrade, copy the appropriate file into your /usr/portmaster/data
directory and run /usr/portmaster/pminstall (version 3.0 or later).



Release Notes for ComOS 3.1.2 --> 3.1.4

This document describes bug fixes made to the PortMaster operating
system between release 3.1.2 and 3.1.4.  There were no enhancements
made in this release.

pm2_3.1.4	This release runs on PM-2, PM-2R, PM-2E, PM-2ER.
pm25_3.1.4	This release runs on PM-25.

Bug Fixes

1. Sending a BREAK command in telnet during an administration session to
   the PortMaster would cause a system reboot.  This has been fixed and
   telnet BREAK is now ignored during these sessions.

2. An ethernet lockup problem that existed in 3.1.3 that would cause it to
   stop transmitting in some network environments, has been fixed.

3. The Annex-D protocol used with Frame Relay on the W1 port of the
   PM-2R and PM-2ER has been enhanced to achieve compliance with the
   ANSI standard and standards defined by the Frame Relay Forum.  These
   changes do not affect standard operational capabilities.  Also in 3.1.3.

4. The device driver for the W1 port of the PM-2R and PM-2ER has been
   improved to detect and recover from certain types of line data
   errors correctly.  Also in 3.1.3.

5. V.25bis dialing has been fixed to work properly on the PM-2R and PM-2ER
   products.

6. When setting a DLCI list for Frame Relay on the W1 port, the PortMaster
   would not update the DLCI list in the configuration if the port had
   a login prompt set for it.  This has been fixed.  Also in 3.1.3.

7. SNMP queries for the software release level now return the correct
   release.  Also in 3.1.3

8. The maximum size of a file stored in the Flash file system was increased
   from 64K to 120K to allow for very large filter rule tables being
   stored in the PortMaster.

9. Previous releases allow filters with blank names to be added.  This
   release will not allow blank filter names.

10.A bug in IP packet reassembly within the PortMaster was fixed.

11.The command "set all host" has been fixed.

12.The command "set all login network twoway" has been fixed.